DAKTRONICS lógó

Leiðbeiningar um meðhöndlun kössa í RTN-3020 seríunni

Lyfta

  1. Use either a forklift or a crane to lift the shipping frames. For single frames, lift from either the forklift pockets with a forklift or from the supplied lift points on the end of the frame with a crane/straps or a spreader beam.
    For stacked frames, lift from either the forklift pockets on the top frame with a forklift or from the supplied lift points on the end of the frame with a crane/straps or a spreader beam.
    Do not forklift stacked frames from the bottom frame, as this is unstable and could result in serious injury to the operator and/or damage to the product. Refer to Figure 1.DAKTRONICS RTN-3020 Series Section Crate Handling - Fig 11: Strap
    2: Forklift pocket
    3: Top frame
    4: Bottom frame
    Figure 1: Lift Methods
  2. Ensure the straps are at a minimum 45° angle or greater if using a crane/straps to lift the frames. Refer to Figure 2.

DAKTRONICS RTN-3020 Series Section Crate Handling - Fig 21: Strap
2: Forklift pocket
3: Top frame
4: Bottom frame
Figure 2: Strap Angle (Front & Side View)

Taktu í sundur

  1. Remove the M12 hardware from the stacked frame support brackets on the frames to separate the top and bottom frames (if applicable).
    Unstack the frames and remove the stretch wrap and the top horizontal runners from the frames. Refer to Figure 3.DAKTRONICS RTN-3020 Series Section Crate Handling - Fig 3Figure 3: Separate and Unstack Frames
  2. Use the hex security bit (Daktronics part number TH-1170) supplied in the toolkit to unlatch the beverage shroud. Flip the beverage shroud open and insert lift eyes in the top of the first display section. Refer to the RTN-3020 Series Section Basics Quick Guide (DD5638341). Attach the crane to the lift points. Refer to Figure 4 for the section lift order and to Figure 5 for proper configurations.

DAKTRONICS RTN-3020 Series Section Crate Handling - Fig 4

Mynd 4: Lyftiröð kafla (framan View)

Stöðugt

Mynd 5 sýnir stöðugar og óstöðugar stillingar.

DAKTRONICS RTN-3020 Series Section Crate Handling - Fig 5

Figure 5: Stable vs. Unstable Crate Configurations (Side View)

Stöðugar stillingar

  • Any four or five sections
  • Three middle sections
  • One outside section on each side and one center section
  • Two outside sections
  • One center section

Óstöðugar stillingar

  • Tveir hlutar á annarri hliðinni
  • Einhver einstakur hluti á ytri stöðum

DAKTRONICS lógó

201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
DD5638339
Opinber 00
19 júní 2025

Skjöl / auðlindir

DAKTRONICS RTN-3020 Series Section Crate Handling [pdfNotendahandbók
RTN-3020, RTN-3020 Series Section Crate Handling, RTN-3020 Series, Section Crate Handling, Crate Handling, Handling

Heimildir

Skildu eftir athugasemd

Netfangið þitt verður ekki birt. Nauðsynlegir reitir eru merktir *